Reassembling the Singer 206 Motor

As you may remember back in December 2013 (here)  I took the Singer 206 industrial motor apart in order to replace the bearings.  It sat around in pieces for a year (just over actually) before we got around to removing the bearings and replacing them.  I wish we hadn't put it off so long as it only took 2 days to do!

First we removed the outer, easier, bearing using a gear puller and then we removed the shaft, this left us with one bearing lodged inside the casting and held in with a circlip.  We ran a screwdriver behind the circlip and then we had all three bearings out.  It cost us $35 to buy replacement bearings but I figured it was cheaper than buying another 206.  Below are images:

First bearing removed, second still on shaft

Arrow pints to the circlip holding the bearing in

Using the gear puller to remove the end of the motor and the second bearing

The shaft of the motor, without the casing.

When it came to reassembling the motor and attaching the wires, I was glad I had taken so many photos before but I still could never quite find the right photograph!  While we were doing electrical work on it, we decided to shorten the power lead, so as to cut off a damaged bit.  This resulted in having to rewire the switch on the table.

Switch inside

Despite our concerns the motor now works fine and is MUCH quieter than it was before.  We are considering putting rubber washers on the bolts that hold it on to the table though as the table is hollow and acts as an amplifier.

In other news, I have been quite busy and managed to miss Tallulah Bankhead's birthday, however I thought I would still post a couple of pictures of her.  I love many of her quotes as they make me laugh.

When I stop being so lazy I should have a nice post about the beautiful 201K I acquired a while ago.